Patton-electronic Model 1065 Uživatelský manuál

USERMANUALMMOODDEELL 11006655Industrial Synchronous &Asynchronous ShortRange ModemSALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007http:/

17 185.0 OPERATIONOnce you have configured each Model 1065 Series unit properlyand connected the twisted pair and RS-232 cables (see Section 4.0),yo

19 205.3 POWER-UPApply AC power to the Model 1065 by plugging the separate ACpower cable first into the rear panel of the Model 1065 and then into an

21 225.5 POWER-DOWNTurn off the Model 1065 Series by simply unplugging the AC powercord from the wall. There is no power switch.APPENDIX APATTON ELE

23 24APPENDIX BPATTON ELECTRONICS MODEL 1065 FACTORY REPLACEMENTPARTS AND ACCESSORIESPatton Model # Description0805FR...Franc

1 21.0 WARRANTY INFORMATIONPatton Electronics warrants all Model 1065 components to befree from defects, and will—at our option—repair or replace the

3 42.0 GENERAL INFORMATIONThank you for your purchase of this Patton Electronics product.This product has been thoroughly inspected by Patton's

5 6The Model 1065 SRM has three sets of eight switches, yielding 24total DIP switches. The three sets will be referred to as S1, S2 andS3. As Figure

7 8Switch S1-8: Carrier Control MethodThe setting for switch S1-8 determines whether the carrier is “con-stantly on” or “controlled by RTS”. This se

9 103.4 CONFIGURATION SWITCH SET “S3”The DIP switches on S3 set the anti-stream control, local loopbackenable, remote loopback enable and receive (in

11 12Switch S3-5: RS-232 Initiation of Local Loopback TestThe setting for switch S3-5 determines whether or not the Model1065 local analog loopback t

13 144.1.1 Two-Wire Cable Connection Via RJ-45A. The RJ-45 jack on a Model 1065 Series Short Range Modem isprewired for a standard TELCO wiring envir

15 16C. AT&T standard modular color codes:4.3 FOUR-WIRE, MULTIPOINT INSTALLATIONMultipoint operation involves the connection of several terminal