Patton-electronic 1045RC Uživatelský manuál

USERMANUALMODEL 1045RCPowered High Speed Short Range Modem:Rack Mount CardSALES OFFICE(301) 975-1000TECHNICAL SUPPORT(301) 975-1007http://www.patton.c

5.0 OPERATIONOnce you have configured each Model 1045RC and connected thecables, you are ready to operate the units. Section 5.0 describes thepower-

5. If the remote BER test indicates that errors arepresent, andthe local analog loopback/BER tests showed that both Model1045RCs were functioning prop

APPENDIX BMODEL 1045RC CABLE RECOMMENDATIONSThe Patton Model 1045RC operates at frequencies of 64KHz or lessand has been performance tested by Patton

APPENDIX DV.35 INTERFACE STANDARDS (DCE)23BFLRVZDDNNAEKUYCCHHMMDJNTXBBFFLLHMSWAAEEKKAJJPFrame Ground -ARequest to Send -CData Set Ready -EData Termina

1.0 WARRANTY INFORMATION Patton Electronics warrants all Model 1045RC components to befree from defects, and will—at our option—repair or replace the

2.0 GENERAL INFORMATIONThank you for your purchase of this Patton Electronics product.This product has been thoroughly inspected by Patton’s qualifie

3.1.1 CONFIGURATION SWITCH SET “S1”The eight DIP switches on pack S1 set data rate, clock source,async/sync mode and carrier control method. Factory

S2-1 and S2-2: RTS/CTS DelayThe combined settings for switches S2-1 and S2-2 determine theamount of delay between the time the Model 1045RC “sees” RT

JP3: 2-Wire/4-Wire Mode SelectionThe setting for jumper JP3 determines whether the Model 1045RCis operating in 2-wire or 4-wire mode. Be careful not

Line Shield & FRGND (JB2)This jumper affects the line interface. In the connected (closed)position, it links RJ-11 pins 1 & 6, or RJ-45 pins

4.0 INSTALLATIONThis section describes the functions of the Model 1000R16 rackchassis, tells how to install front and rear Model 1045RC cards into th

4.3.1 TERMINAL INTERFACE CONNECTIONThe Model 1045RC is wired as a DCE, and allows for three possibleterminal interface connections: • RS-232C/V.24 (e